by Homer Jon Young | Dec 31, 1969 | Nozzle Circuit
Follow these rules to optimize the flow out of your nozzle circuit! 1. Adjust the pump bypass to produce 250 psi at the unit, never higher. Watch the video, Basics – The Pump (7:41) 2. Each nozzle should operate in the “Target Misting Zone” between...
by Homer Jon Young | Dec 31, 1969 | Controller & Remote, Gen 1.3 Repairs, Gen 3 Repairs
This article will detail the steps of replacing the controller faceplate, as well as the tools and parts necessary for the repair process. IMPORTANT: Before disassembling the controller, touch your hand to a metal object to discharge any static. Time: <5...
by Homer Jon Young | Dec 31, 1969 | Controller & Remote
See the video at Installation – Navigating the Controller (1:50) Set System Mode On the home screen, which shows day and time, press Green ► button to position ▲at top of display to one of four System Modes: OFF – daily agitation cycle only. REM...
by Homer Jon Young | Dec 31, 1969 | Gen 3 Repairs
The primary cause of failure in the remote receiver is water entering the connection with the CAT 5 cable. When replacing the remote receiver, we advise also replacing the receiver cable and antenna. Time: 5 minutes Tools: 5/16″ nut driver Parts: Gen 1.3/3...
by Homer Jon Young | Dec 31, 1969 | iMistAway
Download the iMist2 Setup Guide for printing. Pictured: iMist2 Gateway, antenna, power adapter, ethernet cable Connect Gateway to Internet Locate the modem or router that provides an internet connection to customer’s property. Thread articulated antenna (yellow...
