• Home
  • Categories
    • Gen 3 – Setup
    • Gen 3 – Routine Service
    • Gen 3 – Troubleshooting
    • Gen 3 Repairs
    • Gen 1.3 – Setup
    • Gen 1.3 – Routine Service
    • Gen 1.3 – Troubleshooting
    • Gen 1.3 Repairs
    • iMistAway
    • Nozzle Circuit
    • Controller & Remote
    • Concentrates
    • Parts & Assemblies
    • Leak Diagnosis and Repair
    • Specs, Safety & Warranty

Troubleshooting ERR 3: Responding to an Initial ERR 3

by Preston Baumgartner | Oct 7, 2026 | Leak Diagnosis and Repair, Nozzle Circuit

Error 3 means the actual mist volume was significantly greater than the target volume, most often due to a leak in the nozzle circuit. Before assuming a leak, first confirm the controller’s setup values are correct, ensure that the circuit lines are full, then...

Troubleshooting ERR 3: Diagnosing a Slow (Line-Fill) Leak

by Preston Baumgartner | Oct 7, 2026 | Leak Diagnosis and Repair, Nozzle Circuit

An AFR below the NFR and TOL after sizing points toward a slow “line-fill” leak. A “Line-Fill” leak occurs when there is a small leak that cannot be visually identified during an inspection cycle.   The lines typically have some remaining pressure and...

Troubleshooting ERR 3: Locating a Large Leak

by Preston Baumgartner | Oct 7, 2026 | Leak Diagnosis and Repair, Nozzle Circuit

An AFR greater than the NFR and TOL suggests a leak large enough to find either visually, with a pressure tester, or by process of elimination.   Steps:   1. Locate the leak visually. Run an inspection mist cycle and walk the nozzle circuit while it is...

© Copyright 2026 – MistAway Systems, Inc. – MistAway.com 

  • Follow
  • Follow

How can MistAway help you today?

MistAway Help Assistant

Answers are generated from MistAway Tech Self Help articles and can make mistakes. Always follow product labels and safety instructions. Conversations may be reviewed to improve our help content.